Here, I’ll show you how to change a pair of pierced earrings into clip-ons. You might want to do this because you don’t have pierced ears, or, in this case, the earrings are too heavy to sit nicely with posts.
I couldn’t find the clip-on fixings in my local haberdashery or craft stores, so went online. I spent along time searching various craft sites, but for value and ease I bought a multi-pack from eBay. It has various sellers, so you can choose the colour and shape you like.
Most vintage earrings you will find are clip-ons, and sit covering the earlobe. At the moment, Art Deco designs and big Eighties earrings are on the high street. Some of these will have a design that covers the earlobe, but are for pierced ears. I find the weight stretches my ear and ruins the look. In this case, one of the posts broke from the weight! Clip-ons spread the weight, and keep the earring higher on the ear, giving a vintage look.
To change post earrings to clip-ons, you will need;
- Earrings with a base of 1cm or more
- Clip-on fixings/ notions
- A fine edged sharp tool (use common sense and use responsibly)
- Fine sandpaper or small sanding tool
- Superglue
- Cotton bud
1. Firstly, if the earrings have posts, they can usually be twisted or bent off, but the base fixing will need to be pried off using something sharp and thin enough to work between the metal and the earring base.
(This should only be done by a responsible adult with common sense – work the blade away from you and watch your fingers!)
I didn’t have any special tool, I improvised by looking in the kitchen drawer. I used a fish knife. This is slow and delicate work as you want to avoid scratching the earring.
If they have a hook fixing, a small pair of pliers will loosen the join and you can remove them from the loop. I’ll show how to do this in another post.
2. Once you have prized off the post base, use the soft sandpaper to smooth the earring base ready to fix the clip-on onto the earring. Use a fine/ soft sandpaper to avoid damaging the earring. Wipe the earring base clean and lay back facing up on a sheet of paper.
3. Open the clip-on and put a small blob of glue on the back of the clip base. Place centrally on the earring base and once in the right place, pressing firmly.
4. Use the cotton bud to wipe away any overspill of glue. Leave for 24 hours, or as instructed on the glue packaging.
If you find wearing clip-ons all day makes your ears hurt, buy some rubber pads which can be pushed through the hole on the back of the clip.
The Girl loves vintage 